How to Check and Replace Bike Brake Pads
Rim and disc brakes, step by step.
Before you start
- Difficulty
- Beginner
- Estimated time
- 20 min
- •Hex keys (usually 2–5 mm)
- •Small flat screwdriver or pad spreader
- •Replacement pads matched to your brake model
- •Isopropyl alcohol and a clean rag
- •Use pads made for your exact brake model.
- •Never touch disc rotors or pads with oily fingers.
- •Test brakes at walking speed before riding.
Tools required
Safety
Brake pads wear every time you stop. Checking them takes a minute; replacing them takes less than half an hour and needs only basic tools.
How to tell your pads are worn
- Rim brakes: most pads have wear-indicator grooves. When the grooves are gone, replace the pads.
- Disc brakes: look into the caliper. Replace pads when the friction material is about as thin as the manufacturer's limit, often around 0.5 mm.
- A grinding, metal-on-metal sound means the pads are already past their limit.
Replacing rim brake pads
- 01
Loosen the pad bolt
Loosen the bolt holding the pad holder to the brake arm and remove the old pad or insert.
- 02
Fit the new pad
Install the new pad, noting any arrow that shows the direction of wheel rotation.
- 03
Align it to the rim
Position the pad so it hits the braking surface squarely, not the tire, with the front edge touching very slightly first.
- 04
Tighten and test
Tighten the bolt firmly, then squeeze the lever and check both pads meet the rim at the same time.
Replacing disc brake pads
- 01
Remove the wheel
Take the wheel out so you can see into the caliper.
- 02
Remove the retaining pin
Undo the pad retaining pin or bolt and slide the old pads out.
- 03
Push the pistons back
Gently push the pistons back into the caliper with a plastic tire lever or pad spreader. Avoid metal tools on the pistons.
- 04
Install new pads
Fit the new pads and spring, refit the retaining pin and secure it.
- 05
Bed in the pads
Refit the wheel, pump the lever a few times, then do several controlled stops from moderate speed to bed in the pads.
Frequently asked questions
Should I choose resin or metallic disc pads?
Resin (organic) pads are usually quieter with good initial bite but wear faster, especially in wet, gritty conditions. Metallic (sintered) pads last longer and handle heat better but can be noisier. Check which types your brake supports.
Do I need to bed in new pads?
Yes. Bedding in transfers a thin layer of pad material to the rotor and gives full braking power. Do a series of controlled stops from moderate speed before riding normally.
The Medell. Letter
New rides, workshop guides and reviews, in your inbox.
Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.
Keep reading
Hydraulic Disc Brakes: Bleed or New Pads?
Spongy lever, squealing, or fading power? Each symptom points to a different fix. A troubleshooting guide for hydraulic disc brakes.
How to Adjust Mechanical Disc Brakes
Cable-operated disc brakes need regular adjustment as pads wear. How to centre the caliper, set pad clearance and tune cable tension.
The 2-Minute Pre-Ride Bike Safety Check
Air, brakes, chain, quick releases and a final look-over. A simple pre-ride routine that catches most problems before they leave you stranded.